Our Home Preventative Maintenance Agreement Includes:
- 2 Visits per year- 1 Heat Maintenance Tune-up & 1 A/C Maintenance Tune-up
- 5% discount on all repairs, refrigerant, and service calls.
- 1 year parts warranty on most parts replaced & Upfront Flat-Rate Pricing
- Change filters, ( 1″ standard filters provided by Cool Max)
- Maintenance customers receive up to $600+ in free services annually
A/C Maintenance Check-up Includes:
- Inspect evaporator coil and drain pan
- Clean & flush condensate drain line and condensate pump*
- Check drain & water panel of humidifier*
- Inspect ductwork
- Check for proper air-flow
- Inspect blower assembly
- Oil motors (if applicable)
- Check calibration of thermostat
- Inspect outdoor condenser coil & rinse with water (if water is accessible)
- Check compressor function (weak compressor can damage motors or cause equipment failure)
- Check fan motor amps (weak motor can damage compressor or equipment)
- Check & adjust electrical connections
- Replace 1″ standard size quality pleated filter (we provide filter)
- Check temperature drop
- Inspect blower motor
- Check service valve
- Check contactor for proper operation
- Check start-run-assist for proper operation
- Check outdoor fan motor
- Check refrigerant levels (superheat & sub-cooling)
Heat Maintenance Check-up Includes:
- Inspect heat exchanger
- Check inducer motor bearings
- Inspect vent piping
- Inspect gas valve
- Combusting Gas Check* (on all applicable gas appliances)
- Annual Furnace Inspections Include Carbon Monoxide Testing
- Inspect duct system
- Check carbon monoxide levels
- Perform combustion analysis on all gas appliances*
- Clean pilot assembly
- Replace one 1″ standard size* quality pleated filter (we provide filter)
- Check & adjust electrical connections
- Test & clean flame sensor
- Inspect ignition system
- Check safety switch
- Check pressure switch & clean orifice
- Inspect blower motor & blower wheel
- Check temperature rise
- Check calibration of thermostat
- Check wire connections
- Run system & check gas ignition cycle
- Check humidifier & flush humidifier drain*
- Check inducer motor amperage
- Check blower motor amperage
- Check start-run-assist for proper operation
- Inspect gas line of unit
ADDITIONAL RATES MAY APPLY:
Special order parts, Media air filters, humidifier panel replacement, evaporator coil pull & cleaning, burner removal & cleaning, refrigerant leak search, air flow adjusting & balancing, mold & mildew treatment, refrigerant, replacement of any filters that are special order or not a standard size, chemical cleaning of outdoor condenser coils. If recommended cleaning & repairs are not performed at time of service, additional rates & service call may apply.
*Refrigerant is not included. No warranty on drain lines. If additional drain line flush & cleanings are required an additional charge may apply. Combustion safety test does not include tuning gas appliances. Heavy duty chemical cleaning of condenser coils is an additional charge. There is no warranty on part replacement if all recommended repairs are not performed. There is no warranty on refrigerant. PMA does not include the replacement of any parts or equipment.
Standard Filter Sizes Include: 16x25x1, 16x20x1, 14x25x1, 14x20x1, 20x20x1, 20x25x1